What our customers are saying:
The phone operator was very helpful and made my purchase easy. I will keep this website handy.
Harold
Gillsville, GA
Videos
for Truck Bed Mats
Help Articles
Expert Answers
Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well.…
The Torklift Hitch Extension part #TLE1636 that you referenced can tow a trailer that weighs 6,700 lbs like you what you have but you would need to use a weight distribution system with it to have the needed capacity as without a WD system…
Yes it is. The Black Armour Heavy-Duty Custom Truck Bed Mat item #BA67AR does come in two parts. This mat is confirmed to fit the 8' bed length of the 2022 Ford F-250. We do…
Your 2024 Chevrolet Silverado 3500 will come with a 2-1/2" trailer hitch receiver. If your truck did not come with a reducer for a…
The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
I'm assuming your 2024 F-250 has the 6-3/4' bed. If that is correct, the right tie-downs are in…
The Westin Custom Fit Truck Bed Mat #50-6405 will fit perfectly in your 2022 Ford F-250 Super Duty Short Bed and you won't need to trim anything! Just be mindful that these…
When a camper is loaded on a pickup truck bed there will be a gap between the truck bed rails and the underside of the camper as you show in your photo. No worries there. For your camper tie-downs, it loos as though you have attached the rear ones…
The correct BedRug bed mat for beds with a drop-in liner for a 2011 Ford F-150 with a 5-1/2' bed would be part #BMQ04SCD. The #BMQ04SBD you were looking at would be a fit for…
Yes, the #TLD2142 is exactly what you need for your 2019 Ram 3500 with running boards extending under the truck bed. For the rear, you need the #TLD3112 if you have the factory hitch or #TLR3510 if you have the TorkLift SuperHitch Magnum 30K.
There is not a plug and play adapter for your Lance connector that we are aware of. Typically this is installed by the Lance dealer. A junction box/7-way plug kit like #HS381-9000 is an option you have to convert the camper to match the 7-way RV…
You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without…
